Zooming; Operating Multiple Cameras With The Remote Commander - Sony BRC-X1000/H800 Operation Instructions Manual

Table of Contents

Advertisement

If the camera moves in a different
direction from what you intended
The camera is preset to face toward the right whenever
the b button is pressed. You might wish to reverse the
direction in which the camera moves, for example, when
you change the direction of the camera while checking
the picture on the screen. In such cases, press the 2
(REV) button while holding down the L/R DIRECTION
SET button. To reset the setting, press the 1 (STD)
button while holding down the L/R DIRECTION SET
button.
Arrow button
Movement of the
camera
Note
The above setting changes only the signal emitted from
the remote commander, and does not change the setting
of the camera itself. Therefore, repeat the setting process
for each remote commander if you are using more than
one remote commander.
If the POWER lamp and NETWORK lamp
of the camera flash simultaneously, and
PAN-TILT ERROR! is displayed on the
menu screen
When the camera is moved or turned by hand or by
external shock, the microcomputer inside the camera
may not be able to recall the pan/tilt position properly,
in which case the camera automatically stops.
To reset the pan/tilt position, press the PAN-TILT
RESET button or turn off the camera and turn it on
again.

Zooming

Press either of the ZOOM buttons.
farther away. (Wide
slowly (SLOW side)
Setting
L/R
DIRECTION SET
When you perform pan/tilt operations while the camera
While holding down
is in telephoto mode, the moving speed of the image on
the screen may be a little jerky.
STD
1
Press
Operating multiple cameras with
the remote commander
L/R
DIRECTION SET
While holding down
1
REV
2
Press
2
You can then operate the specified camera(s).
Every time you operate the camera(s) using the remote
commander, the CAMERA SELECT button pressed in
step 2 lights up.
46
ZOOM
SLOW
Subject appears
T
angle)
W
L/R
DIRECTION SET
Zooms in or out
Note
Set the IR SELECT switch on the rear of the
camera you want to operate to 1, 2 or 3.
1 2 3
Press the CAMERA SELECT button on the
remote commander that corresponds to the
number set in step 1.
CAMERA SELECT
1
FOCUS
AUTO
FAR
DATA SCREEN
PAN-TILT
RESET
Subject appears
FAST
closer. (Telephoto)
T
W
Zooms in or out
quickly (FAST side)
IR SELECT
POWER
CAMERA
2
3
SELECT
MANUAL
NEAR
BACK LIGHT

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents