To Lock The Doors; To Unlatch The Trunk; Using The Panic Alarm - Chrysler 300 2017 Owner's Manual

20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

To Lock The Doors

Push and release the lock button on the key fob to lock all
doors. The turn signal lights will flash, and the horn will
chirp to acknowledge the signal.
If the vehicle is equipped with Passive Entry, refer to
"Keyless Enter-N-Go — Passive Entry" under "Things To
Know Before Starting Your Vehicle" for further informa-
tion.
Sound Horn With Lock
This feature will cause the horn to chirp when the doors are
locked with the key fob. This feature can be turned on or
turned off. To change the current setting, refer to
"Uconnect Settings" in "Understanding Your Instrument
Panel" for further information.

To Unlatch The Trunk

Push the trunk button on the key fob two times within five
seconds to unlatch the trunk.
If the vehicle is equipped with Passive Entry, refer to
"Keyless Enter-N-Go — Passive Entry" under "Things To
Know Before Starting Your Vehicle" for further informa-
tion.

Using The Panic Alarm

To turn the Panic Alarm feature on or off, push and hold
the Panic button on the key fob for at least one second and
release. When the Panic Alarm is activated, the turn signals
will flash, the horn will pulse on and off, and the interior
lights will turn on.
The Panic Alarm will stay on for three minutes unless you
turn it off by either pushing the Panic button a second time
or drive the vehicle at a speed of 15 mph (24 km/h) or
greater.
NOTE:
• The interior lights will turn off if you place the ignition
in the ACC or ON/RUN position while the Panic Alarm
is activated. However, the exterior lights and horn will
remain on.
• You may need to be less than 35 ft (11 m) from the
vehicle when using the key fob to turn off the Panic
Alarm due to the radio frequency noises emitted by the
system.