Chrysler 300 2017 Owner's Manual page 109

• Press the heated seat button
setting on.
• Press the heated seat button
the LO setting on.
• Press the heated seat button
heating elements off.
If the HI-level setting is selected, the system will automati-
cally switch to LO-level after approximately 60 minutes of
continuous operation. At that time, the display will change
from HI to LO, indicating the change. The LO-level setting
will turn off automatically after approximately 45 minutes.
NOTE:
• Once a heat setting is selected, heat will be felt within
two to five minutes.
• The engine must be running for the heated seats to
operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start, the driv-
er's heated seat can be programmed to come on during a
remote start.
once to turn the HI
a second time to turn
a third time to turn the
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 107
This feature can be programmed through the Uconnect
system. Refer to "Uconnect Settings" in "Understanding
Your Instrument Panel" for further information.
WARNING!
• Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes,
spinal cord injury, medication, alcohol use, exhaus-
tion or other physical condition must exercise care
when using the seat heater. It may cause burns even
at low temperatures, especially if used for long
periods of time.
• Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cushion.
This may cause the seat heater to overheat. Sitting in
a seat that has been overheated could cause serious
burns due to the increased surface temperature of the
seat.
Rear Heated Seats
On some models, the two outboard seats are equipped
with heated seats. The heated seat switches for these seats
are located on the rear of the center console. There are two
heated seat switches that allow the rear passengers to
operate the seats independently.
3