All-Wheel Drive (Awd) - If Equipped; Driving On Slippery Surfaces; Acceleration - Chrysler 300 2017 Owner's Manual

Hide thumbs Also See for 300 2017:
Table of Contents

Advertisement

312 STARTING AND OPERATING
ALL-WHEEL DRIVE (AWD) — IF EQUIPPED
This vehicle is equipped with an active on-demand All-
Wheel Drive (AWD) system which makes available opti-
mum traction for a wide variety of road surface and
driving conditions. The system minimizes wheel slip by
automatically redirecting torque to the front and rear
wheels as necessary.
To maximize fuel economy, your AWD vehicle automati-
cally defaults to rear-wheel drive (RWD) when road and
environmental conditions are such that wheel slip is un-
likely to occur. When specific road and environmental
conditions require increased levels of road traction, the
vehicle automatically shifts into AWD mode. Automatic
AWD operation could be activated by outside temperature,
wheel slip, or other predetermined conditions (there may
be a slight delay for AWD engagement after a wheel slip
condition occurs). AWD can also be manually selected by
activating AutoStick mode (+/-), engaging Sport Mode or
activating the windshield wipers for an extended period of
time. Drive mode, RWD or AWD, can be found in the
instrument cluster display. Refer to "Instrument Cluster
Display" in "Understanding Your Instrument Panel" for
further information.
NOTE: If the "SERVICE AWD SYSTEM" warning message
appears after engine start up, or during driving, it means
that the AWD system is not functioning properly and that
service is required. Refer to "Instrument Cluster Display"
in "Understanding Your Instrument Panel" for further
information.
CAUTION!
All wheels must have the same size and type tires.
Unequal tire sizes must not be used. Unequal tire size
may cause failure of the front differential and/or the
transfer case.

DRIVING ON SLIPPERY SURFACES

Acceleration

Rapid acceleration on snow covered, wet, or other slippery
surfaces may cause the driving wheels to pull erratically to
the right or left. This phenomenon occurs when there is a
difference in the surface traction under the rear (driving)
wheels.

Advertisement

Table of Contents
loading

Table of Contents