Chrysler 300 2017 Owner's Manual page 328

326 STARTING AND OPERATING
ESC modes may also be affected by drive modes – if
equipped.
WARNING!
• In the ESC "Full Off" mode, the engine torque
reduction and stability features are disabled. There-
fore, enhanced vehicle stability offered by the ESC
system is unavailable. In an emergency evasive ma-
neuver, the ESC system will not engage to assist in
maintaining stability. ESC "Full Off" mode is in-
tended for off-highway or off-road use only.
• With the ESC switched off, the enhanced vehicle
stability offered by ESC is unavailable. In an emer-
gency evasive maneuver, the ESC system will not
engage to assist in maintaining stability. ESC "Full
Off" mode is only intended for off-highway or
off-road use.
• The Electronic Stability Control (ESC) cannot pre-
vent the natural laws of physics from acting on the
vehicle, nor can it increase the traction afforded by
prevailing road conditions. ESC cannot prevent all
accidents, including those resulting from excessive
speed in turns, driving on very slippery surfaces, or
hydroplaning. ESC also cannot prevent collisions.
ESC Activation/Malfunction Indicator Light and ESC
OFF Indicator Light
ning. If the "ESC Activation/Malfunction Indicator Light"
comes on continuously with the engine running, a mal-
function has been detected in the ESC system. If this light
remains on after several ignition cycles, and the vehicle has
been driven several miles (kilometers) at speeds greater
than 30 mph (48 km/h), see your authorized dealer as soon
as possible to have the problem diagnosed and corrected.
The "ESC Activation/Malfunction Indicator Light" (lo-
cated in the instrument cluster) starts to flash as soon as the
tires lose traction and the ESC system becomes active. The
(Continued)
"ESC Activation/Malfunction Indicator Light" also flashes
when TCS is active. If the "ESC Activation/Malfunction
WARNING! (Continued)
The "ESC Activation/Malfunction Indicator
Light" in the instrument cluster will come on
when the ignition switch is turned to the ON
position. It should go out with the engine run-