Record DFA 127 User Manual page 31

Configuration
Parameter
Types of arms
Inverse
Spring type
Limit open
ENTRANCE SYS-
TEM
Fire alarm
Control
Interlock type
Door type
Manual DFA 127 Full Power
Setting Factory
range default
Standard Sliding pull-
arm ing
Sliding
pulling
Sliding
pushing
Inheader
Disabled Enabled
Enabled
Display EN 4
only
Disabled Disabled
Enabled
Disabled Enabled
Enabled
Single Single
control control
Master
control
Slave
control
Without Without
interlock interlock
Basic Basic
operator operator
USA
USA Low
Energy
UK
UK Low
Energy
12/2006 Rev. B
Description
Standard arm for pushing opening
Sliding arm for pulling opening
Sliding arm for pushing opening
Special application (for USA only)
Opening of the door by spring ten-
sion in case of power failure.
Springiness value is estimated dur-
ing calibration run (MF 6. light pulse).
Control with FPC 902:
Spring type: EN 4: value from 35-41
EN 5: value from 42-59
EN 6: value from 60-89
Display Unknown, if the value could
not be estimated or lies out of range.
Enabled: The door is hold stronger in
the open position.
Enabled: specific adaptation for the
requirement of the EN-norms for fire
doors.
This setting is effected automatically
under operating conditions. Simula-
tion or Master/Slave-Control can be
set with the FPC 902.
Function not yet integrated
Frequently-used door types can be
chosen for specific applications.
Page 31 of 55