Table of Contents
Advertisement
Important Health and Safety Information for Installers and Service Engineers
Health and Safety at Work Act 1974
Consumer Protection Act 1987
COSHH Regulations 1988
The following information is given as a requirement of the
2 2 2 2 2
above legislation.
Great care is taken by GAH (HEATING PRODUCTS) LIMITED
to ensure that Electrastream systems are designed and
manufactured to meet general safety requirements when
properly used and installed as recommended in this manual.
It is the responsibility of Users and Engineers to ensure that
adequate protective clothing and glasses are worn when
working with the Electrastream system.
SEALS AND INSULATION
SEALS AND INSULATION
SEALS AND INSULATION
SEALS AND INSULATION
SEALS AND INSULATION
Insulation and sealing materials are used in the construction
of the Electrastream cylinders. Units are sealed and when
used in the manner for which they are intended the insulating
and sealing materials do not present any known hazard.
However always observe the following recommendations:-
1.
Avoid inhalation of fibres or dust, wear face mask.
2.
Avoid eye contamination by fibres or dust - wear eye
protection.
3.
As far as possible avoid any skin contact with Fibreglass
Auto/On/Off
Auto/Off
Insulation, Glass Rope, Mineral Wool, Insulation Pads and
HEATING
MODE
Ceramic Fibre.
DOWN
BOOST
ASTREAM
TROL
CAUTION
HIGH VOLTAGE!
DO NOT REMOVE ANY
COVERS (INCLUDING
ROOM THERMOSTAT)
CTS Ltd. 01394 421160
BEFORE ISOLATING
THIS UNIT
Fig. 2-2c Resettable Thermal Trips
In pursuance of a policy of constant development, GAH (HEATING PRODUCTS) LIMITED
reserve the right to change Electrastream parts or design without notice, therefore
certain details included in this manual may not be correct at the time of printing. Any
modification and improvements detailed in this manual does not commit GAH to update
any system previously supplied.
Manual Part No. ...................MAN1019
Manual Ref ..........................ES02
Issue ...................................13
Date .................................... 25/02/13
IMPORTANT
P P P P P atent application 01514800.2
atent application 01514800.2
atent application 01514800.2
atent application 01514800.2
atent application 01514800.2
Operating the Electrastream during
© © © © ©
2010 GAH (HEATING PRODUCTS) L
2010 GAH (HEATING PRODUCTS) L
2010 GAH (HEATING PRODUCTS) L
2010 GAH (HEATING PRODUCTS) L
2010 GAH (HEATING PRODUCTS) LTD.
normal tariffs will increase running
Electrastr
Electrastr
Electrastream is a T
Electrastr
Electrastr
eam is a Trademark of GAH (HEATING PRODUCTS) L
eam is a T
eam is a T
eam is a T
rademark of GAH (HEATING PRODUCTS) L
rademark of GAH (HEATING PRODUCTS) L
rademark of GAH (HEATING PRODUCTS) L
rademark of GAH (HEATING PRODUCTS) LTD.
costs.
HTS REF GAH ELECTRASTREAM 25/02/13
Manual by Harber Technical Services Tel/Fax 01263 515444
E-mail:info@harbertech.co.uk
18
2
2-2.3 Error Displays
When any of the following errors are displayed call service engineer.
ERROR 1
When ‘'Error 1’' is displayed it indicates a faulty or disconnected temperature sensor.
Heating is disabled.
ERROR 2
When ‘'Error 2’' is displayed it indicates:-
1.
The auxiliary 5 amp fuse has blown, or
2.
The pump, motorised valve or room thermostat is faulty, or
Heating is disabled.
ERROR 3
When ‘'Error 3’' is displayed it indicates that all heater elements failed heater test.
Heating is disabled.
ERROR 5
One or more of the controller ‘'set’', ‘'up’', ‘'down’' or ‘'boost’' buttons is stuck or held down.
HEAT 1 ! ! ! ! !
When ! ! ! ! ! is displayed under Heat 1, Heat 2 or Heat 3 it indicates a tri-core element has
failed. Check the resettable thermal trips in the Electrastream Control Unit - see 2-2.4.
2-2.4 Element Resettable Thermal Trips
Each of the three elements of the tri-core heater is protected by a 16amp Resettable
Thermal Trip, these have their reset buttons located on the front of the Electrastream
Control Unit.
In the event of electrical overload on an element the relevant thermal trip will trip out,
when this occurs the button will pop out. Also the control screen will display ‘'!’' under
Heat 1, Heat 2, and/or Heat 3 see fig. 2-2a.
To reset the thermal trip:-
1.
Turn OFF the Electrastream mains isolating switch - see 2-1.1.
2.
Look at the three buttons; button/s that are protruding have tripped out.
3.
Press the button in, if the button stays in when the power is turned on, then trip has
been reset. However if the button pops out again a possible fault exists - contact
the installer.
The Electrastream will still operate with one or two elements working, but this is not
satisfactory and the installer must be contacted to rectify the fault as soon as possible.
2-2.5 Economy Tariffs
Regional electricity suppliers have their own ‘' O ff-Peak’' tariffs that will provide an
economical supply of power for the Electrastream system.
It is vital that the time settings of the Electrastream control unit are set to make the most
use of the available ‘' O ff-Peak’' tariffs.
2-2.6 Normal Tariffs
Normal tariffs are at all times that are not designated for ‘' O ff-Peak’', the cost of electricity
during normal times will be more expensive. Therefore avoid setting heating and hot
water ON during these periods.
TD.
TD.
TD.
TD.
TD.
TD.
TD.
TD.
www.harbertech.co.uk
OPERA
OPERA
OPERATOR CONTROLS
TOR CONTROLS
TOR CONTROLS
TOR CONTROLS
HEALTH & SAFETY
HEAL
HEAL
OPERA
OPERA
TOR CONTROLS
HEAL
HEAL
OTHER MATERIALS
OTHER MATERIALS
OTHER MATERIALS
OTHER MATERIALS
OTHER MATERIALS
SEALANTS, ADHESIVES AND PAINTS
Sealants, Adhesives and Paints are used in the construction of
the Electrastream components. When used in the manner for
which they are intended they do not present any known hazard.
ELECTRIC
ELECTRIC
ELECTRIC
ELECTRIC
ELECTRIC
The Cylinder Tri-Core Heater, Pump, Thermostats and Contactor
Box all have electrical supply of 230V (enough to endanger
life).
Always isolate before connection, adjustment, servicing and
repair.
When the Tri-Core Heater cover is removed high power live
electrical terminals are exposed.
ISOLATE THE TRI-CORE HEATER BEFORE REMOVING ITS
COVER.
Earth protection - Earth Continuity Conductors must be fitted
and must comply with IEE Wiring Regulations.
GAH (HEATING PRODUCTS) LIMITED will not accept
responsibility for any damage or personal injury caused
by not giving due consideration to the above safety
recommendations.
GAH (Heating Pr
GAH (Heating Pr
oducts) Ltd.
oducts) Ltd.
GAH (Heating Pr
GAH (Heating Products) Ltd.
GAH (Heating Pr
oducts) Ltd.
oducts) Ltd.
Building 846
Bentwaters Parks
Rendlesham
Woodbridge
Suffolk IP12 2TW
T T T T T el: el: el: el: el:
01394 421160
01394 421160
01394 421160
01394 421160
01394 421160
Fax:
Fax:
Fax: 01394 421170
Fax:
Fax:
01394 421170
01394 421170
01394 421170
01394 421170
email: mail@gah.co.uk
www.gah.co.uk
TH & SAFETY
TH & SAFETY
TH & SAFETY
2
2
2
TH & SAFETY
2
2
Hide quick links:
Advertisement
Table of Contents
