Adjustment Of The Rear Wheel - progeo Exelle User Manual

It is possible to adjust the back height in 1.5cm intervals.
Remove the rear wheel (see chapter 5.5 Removal of rear
wheels ) to carry out the adjustment.
Using a 4mm Allen key and a 10 mm spanner, remove screws
A and corresponding nuts and washers A
Next, using a 5mm Allen key and a 10mm spanner, remove
screw B and corresponding nut and washer B
Repeat the procedure for both sides of the wheelchair.
Raise or lower the back to the desired height.
Replace the screws into the nearest pre-drilled holes in the frame
and tighten.
When adjusting the back height make sure that the
height on the left is the same as the height on the right.
After carrying out adjustment make sure that the
screws and nuts are securely tightened.
6.4 Adjustment of rear wheel
This adjustment is very important to ensure the correct stability
of the wheelchair.
It is possible to adjust both the height and depth.
Adjustment of height: the plate K of the rear wheel support
can be positioned at six different heights. Proceed by removing
the rear wheel (see chapter 5.5 Removal of rear wheels ).
Remove fixing screws A (4 mm Allen key) and corresponding
nuts and washers A (10mm spanner). Move the mounting
1
plate up or down in line with the corresponding holes on the
frame, pre-drilled at 1.5cm intervals.
Replace the screws and tighten.
Exelle
30
.
1
.
1
(fig 45)
Adjustment of depth: six different positions are possible for the
wheel alignment axle B . The plate K permits axle B to be
positioned in three positions corresponding to the three holes F .
By rotating the plate 180° (see fig 45) it is possible to obtain a
further three positions. Remove the rear wheel (see chapter 5.5
Quick release rear wheels ).
To adjust the depth, remove the axle B (24 mm spanner) and
the corresponding nut and washer.
If it is necessary to rotate the plate, remove screws A (4 mm
Allen key) and corresponding nuts and washers (10 mm
spanner).
Once the components are in the required position replace the
screws and tighten all parts.