Yale HSA3400 Installation, Programming, Operating page 15

Adding the help button
Program your help button before installation and
test in the desired location before mounting.
Programming
1 Follow sections 1 and 3 (Inserting batteries and
Location planning).
2 With the system in learn mode, press and hold
the red button on the help button – the LED will
light momentarily and your system will confirm
the transmission.
3 Take your system out of learn mode.
• The help button can be tested by entering learn
mode (see user guide) and activating the help
button. The siren will beep in response to the
activation. Please ensure you exit learn mode
after testing.
Using
To activate, press and hold the red button for at
least 2 seconds – LED will light momentarily and
the alarm will be activated.
To silence an alarm, press and hold down the
red button, after 10 seconds the LED will light
momentarily for a second time – alarm will be
silenced
• Please note that silencing the alarm with the
help button does not reset the system. If the
alarm is armed prior to activation, the system
will re-arm after being silenced with the help
button.
Adding the smoke detector
1 Follow sections 1 and 3 (Inserting batteries and
Location planning).
2 With the system in learn mode, press the
learn/test button on the smoke detector until
siren confirms.
3 Exit learn mode.
• The smoke detector will indicate a fire by
sounding the built-in siren, lighting the LED, and
sounding the external siren.
• The smoke detector will produce a warning
beep and the LED will flash every 30 seconds if
the batteries are near exhaustion.
• The learn/test button can be used to test the
smoke detector. The detector will sound a two-
tone confirmation and the siren will beep.
Please ensure that you test smoke detectors
regularly.
Adding further PIRs and door/window
contacts
1 Disable tamper and enter learn mode.
2 Press the learn button in the device. The siren
will confirm.
3 Exit learn mode and after mounting the
detector, enable tamper protection.
Adding extra keypads
Additional keypads can be added to the system,
for instance alongside another point of entry/exit.
• Please note that the Home feature (extra button
on accessory keypads) is not used on the
HSA3400 system.
1 Using your original keypad, disable the system
tamper and enter the learn mode.
2 Enter 0000 on your new keypad, then press
TEST. The 'Tx' LED will flash showing that it is
in program mode.
3 Press TEST again, then 1. Keypad will beep and
the siren confirm.
4 Press OFF twice on the new keypad.
5 Using either keypad, enable system tamper
(after mounting new keypad) and exit the learn
mode.
Adding extra keyfob remote controls
1 Using your original keyfob, enter the learn
mode.
2 Press the Arm button on your new keyfob, the
siren will confirm.
3 Exit learn mode using either keyfob.
• Now both keyfobs can be used to operate the
alarm and learn further devices (including extra
keyfobs) into the system.
www.ukpanels.com
15