G: Printer Buttons And Lights - Brady BradyJet J5000 Operator's Manual

7. Defective Printhead/Cartridge Replacement Procedure.
Notes on Ink Cartridge/Printhead Replacement

G: Printer Buttons and Lights

Button/Cover Functions:
RESUME/FEED-BUTTON
Printer State
SYSTEM IDLE:
SYSTEM PAUSED:
SYSTEM BUSY PRINTING
PAUSE/UNLOAD-BUTTON:
Printer State
SYSTEM BUSY PRINTING:
COVER OPEN:
SYSTEM PAUSED:
CANCEL-BUTTON:
COVER OPEN SENSOR:
WHEN COVER OPENED:
COVER CLOSED:
BOTTON COMBINATIONS
LOAD-BUTTON and
J5000 Operator's Guide, Rev. 1.53
quality problem is to have backup printheads and cartridges available for
comparison testing. If one color is missing, replace that color cartridge(s). Next
try replacing the printhead.
If you think your Ink Cartridge/Printhead is defective, please contact Brady
Technical support to arrange for a replacement. Brady Technical support may
ask you to perform troubleshooting before sending a replacement cartridge or
printhead.
• All replacements for defective cartridges or printheads must be processed
through Tech Support.
• To receive replacement cartridges, you may be required to send in your
defective cartridges/Printhead.
• Tech Support will perform the cleaning procedures and tests mentioned
above on all cartridges/Printheads received.
• Tech Support will not replace cartridges with less than 50% ink remaining.
• Printheads with zero percent life remaining will not be replaced.
• Printheads with greater than zero percent life remaining prints may be
replaced depending on the description and circumstances of the failure at
the discretion of Brady Tech Support.
Press Action
Feeds to next label, Cuts the label if cutter enabled. Cuts
current label in LOAD BUTTON CUT MODE.
Unpauses system
Retries to correct error or just clears error state
Press Action
Pauses system
Unloads stock
Unpauses system/Resumes printing
Cancels current job in progress
Pauses current job if active, will finish printing current label.
Moves Carrier to Head Change Position
If closed after it has been opened the Printer will be in a
pause mode. Press Resume/Feed to continue
Hold buttons down until Wireless symbol changes; this will
27