Brady BradyJet J5000 Operator's Manual page 4

Agency Compliance and Approvals
FCC Compliance Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including interference that may
cause undesired operation.
For Users in the United States
FCC Notice-US Only
Warning: This product is intended to be supplied by a UL listed Direct Plug-In Power
Supply marked "Class 2"or a UL listed ITE Power Supply marked "LPS" with output rated
12VDC, 4.5A or higher. This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. In a domestic
environment this product may cause radio interference, in which case the user may be
required to take adequate measures. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
•
•
•
Use of shielded cables is required to comply with the Class A limits of Part 15 of the FCC
Rules. You are cautioned that any changes or modifications not expressly approved in
this manual could void your authority to operate and/ or obtain warranty service for this
equipment.
Canada
ICES-003 Class A Notice, Classe A
Industry Canada ICES-003: CAN ICES-3 (A)/NMB-3(A)
This device complies with Industry Canada license-exempt RSSs. Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
J5000 Operator's Guide, Rev. 1.53
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
iii