Table of Contents
Advertisement
2.
Remove any shipping tape from your label stock roll to ensure that it can unroll
3.
freely; making certain that no adhesive portion is exposed. It is important to note
that any exposed adhesive surface can attach itself to the inner workings of the
print mechanism and cause a media jam.
Place your roll of label stock, so that labels unwind with the labels facing upward, on
4.
the Roll Arm and push it inward until it touches the Roll Stop.
Roll Guide
Flip up the Roll Guide and slide it inward until it touches the label stock. The Roll
5.
Guide will automatically pull back slightly to the correct position. There should be
approximately a 0.04" (1 mm) gap between the roll guide and the roll.
Pull the Movable Throat Guide outward to make room for the label stock.
6.
Place the leading edge of the label stock under the "Label Stock"
7.
symbols on the Throat Guides. The label stock should be placed far
J5000 Operator's Guide, Rev. 1.53
Lower the Roll Guide and pull it outward to make room for your label stock.
Roll Stop
Roll Arm
7
Hide quick links:
Advertisement
Table of Contents
