Genie WIP1VD User Manual page 10

Network Camera User Manual

Access through PPPoE dial-up
Network connection
You may access the camera through PPPoE auto dial-up. The setting steps are as follow:
① Go to ConfigNetwork ConfigPort menu to set the port number.
② Go to Config Network ConfigIP Address menu. Check "PPPoE" and then input the
user name and password which you can get from your internet service provider.
③ Go to Config Network ConfigDDNS Config menu. Before you configure the DDNS,
please apply for a domain name first. Please refer to 4.4.5 DDNS Configuration for detail
information.
④ Open the IE browser and input the domain name and http port to access.

Access through static IP
Network connection
The setting steps are as follow:
① Go to ConfigNetwork ConfigPort menu to set the port number.
② Go to Config Network ConfigIP Address menu to set the IP address. Check "Use the
following IP address" and then input the static IP address and other parameters.
③ Open the IE browser and input its WAN IP and http port to access.
6