Related Manuals for Genie WIP2BVLG
Summary of Contents for Genie WIP2BVLG
- Page 1 2MP IP Lite IR Varifocal Bullet Camera with 2.8-12mm Lens WIP2BVLG Quick Start Guide Please read these instructions carefully before operating the unit and keep for further reference.
- Page 2 Intro Section Please read this instruction carefully before operating the product and keep it for further reference. All examples and pictures used here are for reference only. The contents of this manual are subject to change without notice. CAUTION: • If the product does not work properly, please contact your dealer or the nearest service centre.
-
Page 3: Table Of Contents
Contents 1.0 Introduction ......................4 1.1 Product Features ...................4 1.2 Product Dimensions ..................4 1.3 Contents ......................4 1.4 Specification ....................5 2.0 Overview ......................6 3.0 Installation ......................7 4.0 Network Connection ...................9... -
Page 4: Introduction
1.0 Introduction The Genie WIP2BVLG is an IP IR varifocal bullet camera with a 2.8-12mm lens and 20- 30m IR distance in ideal conditions. The camera has 1080p full real time coding as well as remote monitoring in a grey finish. -
Page 5: Specification
Quick Start Guide 2MP IP Lite IR Varifocal Bullet Camera with 2.8-12mm Lens 1.4 Specification Image Sensor 1/3” CMOS Image Size 1920 x 1080 Electronic Shutter 1/25s ~ 1/100,000s Effective Pixels 752 (H) x 582 (V) Camera Minimum Illumination 0 Lux (IR LED On) Lens 2.8 ~ 12mm Video Format... -
Page 6: Overview
2.0 Overview Sunshield 4. Network Cable 2. Bracket 5. MIC In Cable 3. Mounting Base 6. Power Cable Security Cap DC12V It is recommended to install the security cap for outdoor installation. If the PoE switch is used, the DC12V power supply is not required. Connecting Network Cable Loosen the nut from the main element. -
Page 7: Installation
3.0 Installation Please make sure that the wall or ceiling is strong enough to withstand 3 times the weight of the camera. Please install the camera in and under a dry environment and place the cover of the camera within 4 hours of removing it. Drill the screw holes and the cable hole (if you want to route through the ceiling) on the wall or ceiling according to the drill template. - Page 8 Quick Start Guide 2MP IP Lite IR Varifocal Bullet Camera with 2.8-12mm Lens 5. Focus and zoom adjustment (If the model you get is prime lens, please skip this step). Remove the lens cover and then adjust the focus and zoom screws to get a clear image.
-
Page 9: Network Connection
4.0 Network Connection Access the Camera through the IP Tool Make sure that the camera and the PC are well connected via LAN. 2. Find the IP-Tool from the CD and then install it in the computer. After that, run the IP Tool as shown below. - Page 10 Quick Start Guide 2MP IP Lite IR Varifocal Bullet Camera with 2.8-12mm Lens Direct Access Through IE The default network settings are as shown below: IP address: 192.168.226.201 Subnet Mask: 255.255.255.0 Gateway: 192.168.226.1 HTTP: 80 Data Port: 9008 You can use the above default settings when you log into the camera for the first time. Set the IP address of the PC and make sure the network segment should be as the same as the default settings of IP-CAM.
- Page 11 Sales +44(0)1707 330541 Enquiries sales@genieproducts.co.uk Website www.genieproducts.co.uk...