2mp 4-in-1 ahd ir vandal resistant dome camera with 2.8-12mm auto focus lens (10 pages)
Summary of Contents for Genie WIPX4FD
Page 1
4MP H.265 IP IR Flat Mini Dome with 2.8mm Lens and Facial Recognition WIPX4FD Quick Start Guide Please read these instructions carefully before operating the unit and keep for further reference.
Page 2
Intro Section Please read this instruction carefully before operating the product and keep it for further reference. All examples and pictures used here are for reference only. The contents of this manual are subject to change without notice. CAUTION: • If the product does not work properly, please contact your dealer or the nearest service centre.
1.0 Introduction The Genie WIPX4FD is a 4MP IP IR flat mini dome camera with a 2.8-12mm lens. The camera features intelligent analytics as well as facial recognition when paired 1.1 Product Features • 4MP (2592 x 1520 ) H.265 full real time coding •...
Quick Start Guide 4MP H.265 IP IR Flat Mini Dome with 2.8mm Lens and Facial Recognition 1.4 Specification Image Sensor 1 / 3 “CMOS Image Size 2592 x 1520 Electronic Shutter 1 / 30 s ~ 1 / 100000 s Iris Type Fixed Iris 0.005 Lux @ F1.6,AGC ON, 0 Lux with IR...
Page 6
Quick Start Guide 4MP H.265 IP IR Flat Mini Dome with 2.8mm Lens and Facial Recognition Network RJ45 Video Output Audio 1CH audio input, 1 CH built-in MIC Interface Alarm Storage Built-in Micro SD card slot, Up to 128GB Hardware Reset Ingress Protection IP66 Power Supply...
2.0 Overview Micro SD card slot 2. Light sensor 3. Reset 4. Ethernet connector (PoE) 5. Audio input 6. Power connector Lower Dome 8. Ground 9. Microphone Security Cap DC12V • It is recommended to install the security cap for outdoor installation. •...
3.0 Installation Please make sure that the wall or ceiling is strong enough to withstand 3 times the weight of the camera. Please install the camera in and under a dry environment. Drill the screw holes and the cable hole on the wall according to the drill template. 2.
Page 9
Quick Start Guide 4MP H.265 IP IR Flat Mini Dome with 2.8mm Lens and Facial Recognition 6. Replace the lower dome to the camera and make sure the light sensor can be seen from the outside. If the light sensor is hidden, please re-adjust the lens.
4.0 Network Connection Access the Camera through the IP Tool Make sure that the camera and the PC are well connected via LAN. 2. Find the IP-Tool from the CD and then install it in the computer. After that, run the IP Tool as shown below.
5.0 Camera Maintenance Transparent dome is an optical element. As dirt, dust or fingerprints on the dome will reduce the clarity of the image, please don’t touch or wipe the cover surface directly during installation and use. Please refer to the following cleaning tips to clean it. •...
Need help?
Do you have a question about the WIPX4FD and is the answer not in the manual?
Questions and answers