Appendix 8 Alert List And Codes - Furuno FM-8900S Operator's Manual

APPENDIX 8 ALERT LIST AND CODES

To remove the alert pop-up messages, press the CANCEL key.
Note: The alert ID number display format changes depending on whether a BAMS is connected.
If a BAMS is connected, the alert code is output in six digits (EG: "POSITION LOST" - 610014). If
no BAMS is connected, the alert code is output in three digits (EG: "POSITION LOST" - 014).
Alert BAM
Displayed Message
ID ID
013 610013 Position data is not updated!
Position was older than 4H.
Update it.
014 610014 Lost position!
Position was older than 23.5H.
You must update position!
210 610210 RX PLL UNLOCK!
CH:XX
Unable to receive.
213 610213 DSC PLL UNLOCK!
CH:70
Unable to receive DSC message.
220 610220 TX PLL UNLOCK!
CH:XX
Unable to transmit.
340 610340 TX power reduced.
RF AMP heated.
500 610500 DISTRESS ALERT message
received! *
510 610510 URGENCY INDIVIDUAL
message received! *
520 610520 SAFETY INDIVIDUAL
message received! *
530 610530 ROUTINE INDIVIDUAL
message received! *
610 610610 Communication error with
RemoteHS!
630 610630 EPFS error!
*: The displayed message for received DSC messages changes according to the message contents,
however the alert ID, priority, category and measures taken do not change.
AP-30
Priority Category Meaning(OM)
Caution Position data is not
B
current.
Caution B Position data is not
current.
Caution B RX circuit PLL is
unlocked. Unable to
receive.
Caution B DS circuit is unlocked.
Unable to receive
DSC messages.
Caution B TX circuit is unlocked.
Unable to transmit.
Caution B RF amplifier is too
hot. Transmission
power is reduced.
Warning Distress level message
A
received.
Warning A Urgency level message
received.
Caution B Safety level message
received.
Caution B Routine level message
received.
Communication
Caution B
between the transceiver
unit and a remote
handset is interrupted
or lost.
No position data input for
Caution B
ten minutes.
Note: This message
does not appear when
[INPUT TYPE] in the
[POSITION] menu is set
to [MANUAL].
Measure(OM)
Update current
ship position
manually.
Update current
ship position
manually.
Contact your
dealer.
Allow the
transceiver
unit to cool. If
the problem
persists,
contact your
dealer.
Check the
contents of the
message.
Check connec-
tion to handset.
If the problem
persists, contact
your dealer.
Input position
data.