Furuno FM-8900S Operator's Manual page 131

Alert BAM
Displayed Message
ID ID
730 * Cannot print. Check printer.
610950 Communication Error with BAM! Caution
Unable to transmit!
Hardware error occurs.
Check alarm status.
Unable to transmit!
Hardware error occurs.
Check alarm status.
System was rebooted.
The unit will not transmit any
DSC call until own ship's MMSI
is entered.
*: This alert is not generated if a BAMS is connected.
Note: Priority and category for alerts is dependent on the alert management system in use. The
tables above show the priority and category for BAMS.
APPENDIX 8 ALERT LIST AND CODES
Priority Category Meaning(OM)
Printer problem.
Cannot print.
B Position data is not
current.
Unable to transmit. TX
circuit's PLL may be
unlocked.
Unable to transmit. TX
circuit's PLL may be
unlocked.
An internal error has
occurred. The system
has rebooted.
You tried to send a
DSC message but your
MMSI has not been
registered in the
equipment.
Measure(OM)
Check printer
connection,
power, paper.
Update current
ship position
manually.
Contact your
dealer.
Contact your
dealer.
The system will
automatically
restart. If the
problem persists,
contat your
dealer.
Enter the MMSI
no. of your ship.
AP-31