Circuit Board C And Fuse - ELNA 6004 Service Manual

Elna International Corps. SA
To remove:
1. Remove the rear cover.
2. Remove three (3) set screws A and circuit board C (See page 20).
3. Remove three (3) set screws B and remove case cover D.
4. Replace fuse or circuit board C.
To fit:
5. Attach the case cover with three (3) set screws B.
6. Attach the circuit board C with three (3) set screws A.
7. Attach the rear cover.
NOTE: To replace the fuse, push the fuse out from fuse holder a with screwdriver as shown
below. Two specified fuses are used for circuit board C.
Fuse1 :
Fuse 2 :

CIRCUIT BOARD C AND FUSE

120 - 125V =
220 - 250V =
120 - 125V =
220 - 250V =
6004
2,5 A
2,0 A
3 A
5 A
Page 19
Service manual