Status Messages, Lcd Messages And Led Behaviors - Kodak verite 55 plus Extended User Manual

Status messages, LCD messages and LED behaviors

The Status information will report problems with the unit. Take the proper action by referring to the following table.
»
Refer to "Check print status from your PC" on page 24.
•
LED lighting patterns
Blinking 1
Lights up for 1 sec.
Blinking 2
Lights up very rapidly
Blinking 3
Blinking very rapidly 2 times
Blinking 4 Blinking very slowly
Status messages LCD messages
Communication failure
(No Error message)
Insert Paper
Paper Jam
Check cartridge lock
English
No light for 1 sec.
No light for more than 1 sec.
No light for 1 sec.
LED behaviors
Ready
Insert Paper
Please insert paper
blinks as pattern 1
and press OK .
Back Start
OK
Paper Jam
Clear jam and
OK
press . blinks as pattern 1
OK
Cartridge Error
Please check
ink cartridge lock.
blinks as pattern 1
OK
And retry by .
OK
Wireless LED — indicated by
ECO LED — indicated by
Power LED — indicated by
Blinking 5 Blinking slowly
Blinking 6 Blinking rapidly
Blinking 7 Blinking very rapidly
Blinking 8 Blinking very rapidly 4 times
Blinking 9 Blinking slowly (in Power-on mode)
Unit status or possible causes
Communication failed on the unit.
– Check the AC plug is connected to the AC
outlet properly, the unit is turned On, or the
connection environment (USB, Wireless) to the
unit. Then follow the procedures by showing the
help text on your connected unit.
• If this error occurs occasionally, refer the
latest troubleshooting to visit our website at
www.kodakverite.com/support
• If you cannot solve the problem, disconnect
the AC plug and contact an authorized service
center.
Insert Paper.
– Check the paper support.
• Set specified paper in the paper support, and
then press .
A paper jam has occurred inside of the unit.
– Firmly grasp the paper, and then gently pull it
out.
Press , to restart the rest of the print job.
• If you want to cancel the print job, then press
.
An ink cartridge is not installed correctly.
– If the packaging paper is stuck in the ink door,
remove it.
– Reinstall the cartridge, then close the lid completely.
• Confirm the ink cartridge is correctly installed,
then press .
59
No light for 2 sec.
Refer to
"Insert paper into the paper
support"
on page 25.
"Clearing paper jam in
the unit"
on page 52.
"Unpack" on page 11.
"Install ink cartridges" on
page 12.
"Changing the ink cartridge"
on page 51.
Continued on next page.