Kodak verite 55 plus Extended User Manual page 63

Status messages LCD messages
Scanner Error:
Unplug and replug the
and Unplug and replug
power cable.
Memory Error:
Unplug and replug the
power cable.
<Alignment in progress...>
Alignment in progress
Wi-Fi Module Error
Wi-Fi Module Error:
Unplug and replug the
power cable.
NFC Module Error:
Unplug and replug the
power cable.
English
LED behaviors
Scanner Error
Please check
Scanner Unit
and
the power cable.
blink as pattern 1
Memory Error
Unplug and replug
the power cable.
and
blink as pattern 1
blinks as pattern 6
Unplug and replug
the power cable.
and
blink as pattern 1
NFC Module Error
Unplug and replug
the power cable.
and
blink as pattern 1
Unit status or possible causes
Pull out the AC plug.
– Wait at least 30 seconds, then connect the AC
plug back into the socket.
• If this error occurs occasionally, refer the
latest troubleshooting to visit our website at
www.kodakverite.com/support
• If you cannot solve the problem, disconnect
the AC plug and contact an authorized service
center.
Pull out the AC plug.
– Wait at least 30 seconds, then connect the AC
plug back into the socket.
• If this error occurs occasionally, refer the
latest troubleshooting to visit our website at
www.kodakverite.com/support
• If you cannot solve the problem, disconnect
the AC plug and contact an authorized service
center.
Please confirm the Menu display of the device.
– Print jobs cannot start while running alignment.
Run the alignment or run cancel operation on the
device.
Pull out the AC plug.
– Wait at least 30 seconds, then connect the AC
plug back into the socket.
• If this error occurs occasionally, refer the
latest troubleshooting to visit our website at
www.kodakverite.com/support
• If you cannot solve the problem, disconnect
the AC plug and contact an authorized service
center.
63
Refer to
"Power cycling"
on page 53.
"Power cycling"
on page 53.
"Power cycling"
on page 53.
Continued on next page.