Contec FX-DS540-APP User Manual page 75

5 Software Setup
Detailed setting
You can select the types of events to be logged. Setting [Log in], [Log Out], [Log in refusal], and
[Roaming] to "ON" allows the selected events to be logged. Setting them to "OFF" prevents them from
being logged. All of the events are set to "ON" by factory default.
Table 5.4 Events to Be Logged
Event
Start
Link Up
Link Down
Login
Logout
Login NG
Roaming
Tunnel Start
Tunnel Stop
Application Login
Application Logout
Write Firmware
Write Config
Manual Reset
66
Indicates that the AP has been activated.
Indicates that the wired link has been connected and the link speed.
Indicates that the wired link has been disconnected.
ndicates the MAC address of the wireless terminal connected to the AP.
Indicates the MAC address of the wireless terminal disconnected from the AP.
Indicates that the filter function rejected an attempt to log in by an
unregistered wireless terminal.
Indicates the MAC address of the wireless terminal roaming into the AP.
Indicates the MAC address of the wireless terminal that has started IP
tunneling.
Indicates the MAC address of the wireless terminal that has terminated IP
tunneling.
Indicate the IP address of the terminal that has used an application (such as
telenet or FTP).
Indicates the termination of an application and the IP address of the terminal
that used the application.
Indicates that firmware has been reprogrammed. (Example: Update from
Ver1.15 to Ver1.20)
Indicates that the Config file has been edited.
Indicates that the AP has been restarted by the terminal or browser.
Introduction
FX-DS540-AP, FX-DS540-APP