Table of Contents
Advertisement
Channel DIP switch settings
When this function is enabled, the channel number set by the DIP switch is used. If disabled, the channel
number setting is used.
Table 5.3 Channel DIP Switch Settings
DIP Switch
CHANNEL1
CHANNEL2
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
Channel number
Channel number setting. This setting is used if the DIP switch channel number setting is disabled. The
range of channel numbers is 34, 38, 42, or 46.
Speed
Sets the wireless transmission speed.
For operation in the 5 GHz band, select "Auto", "54", "48", "36", "24", "18", "12", "9", or "6".
For operation in the 2.4 GHz band (with the FX-DS110-CFC plugged), select "Auto", "11", "5.5", "2",
"1", or "2/1". The factory default setting is "Auto".
WEP
This specifies whether to enable the WEP function. Specify the number of the WEP key to use for data
transmission in the default transmit key setting. Enter WEP keys in hexadecimal format (0 - 9 and a to f
or A - F). Enter 10 digits for a 64-bit key and enter 26 digits for a 128-bit key and enter 32 digits for a
152-bit key. The keys are not used if this function is disabled. The factory default setting is "Disable".
Note that enabling the WEP function prevents communications from being performed between terminals
with different WEP keys.
WSL(Wireless Security Link)
Select whether to encrypt wireless transmission data. Note that WSL-enabled and WSL-disabled
terminals cannot communicate with each other. The factory default is "Disabled". The WSL key can be
set only when WSL has been enabled. Note, also, that terminals different in WSL key cannot
communicate with other.
Transmission output
For wireless LAN in the 5 GHz band, you can decrease the transmission output to "50%" or "25%" by
software setting. To decrease the output, select either. The factory default is "MAX".
FX-DS540-AP, FX-DS540-APP
Channel
Number
CHANNEL3
OFF
34
ON
38
OFF
42
ON
46
5 Software Setup
61
Advertisement
Table of Contents
