Contec FX-DS540-APP User Manual page 35

3 Setup
Connectors
Table 3.3 Connectors
Item
CF1 Accepts the firmware storage CF card. (TYPE I)
CF2 Accepts the firmware storage CF card or an optional CF card such as
the FX-D110-CFC. (TYPE II)
When the device is shipped, the firmware storage CF card is plugged.
TO use the FX-DS110-CFC, plug the firmware storage CF card into
CF1.
COM Connects a terminal to make various settings and to update firmware.
UTP 10/100M Connects to a 10BASE-T or 100BASE-TX LAN.
Ground terminal Grounds the AP via the ground terminal.
Power supply 5VDC power supply input jack. When no AC power supply is available,
jack supply the power using this connector.
- Power supply specifications: 5VDC±5% Max. 1.6A
- Power supply plug
- Specification: EIAJ RC-5320A Voltage category 2
- Polarity: Outside terminal is negative (-) and center terminal is
positive (+)
- Plug diameter:
diameter)
CAUTION
Use either the AC power supply or DC power supply on the FX-DS540-AP/APP. Using both power
supplies at the same time may damage the AP.
Only the DC power supply can be used for the FX-DS540-APP.
26
Operation / function
4.0mm (external diameter), 1.7mm (internal
FX-DS540-AP, FX-DS540-APP