Pole Mounting Using Pmk1 - Cisco Aironet 1570 Series Installation Manual

Pole Mount Kit 1
Figure 3-13 PMK1 One-Piece Pole Mounting Bracket
4
3
1 and 3 Key hole slots for the four M8 x 12mm hex
head bolts, using which the AP is mounted on
PMK1
For mounting the AP using PMK1, see

Pole Mounting Using PMK1

You can use PMK1 for vertically mounting the AP on vertical poles, with diameters ranging from 2 to 6
inches (50 to 152 mm). Ensure that you have the materials listed in
Table 3-4
Material Needed
One PMK1 pole mount bracket
Four M8 x12mm hex head bolts with built-in washers
Two stainless steel band straps (adjustable to fit poles of 2– 6
inches, 50–152 mm). These band straps have a
pull-lock-tighten system.
13 mm box-end wrench
5/16 socket head wrench for tightening the steel band straps
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
3-20
1
2
2 and 4 Slots for passing the steel band straps through.
Materials Needed to Mount the AP using PMK1
Pole Mounting Using PMK1, page
In Kit?
Yes
Yes
Yes
No
No
Chapter 3 Mounting the Access Point
3-20.
Table 3-4 to mount the AP.
OL-32138-01