Pole Mounting The Access Point With Air-Acc1530-Pmk1 - Cisco AIR-AP1542I-*-K Installation Manual

Chapter 2 Installing the Access Point

Pole Mounting the Access Point with AIR-ACC1530-PMK1=

The AIR-ACC1530-PMK1= mounting kit contains a mounting bracket that can be used for both wall
mounting and pole mounting. This kit can be used to install the access point on a pole, mast or streetlight.
It supports metal, wood or fiberglass poles from 2 to 8 inches in diameter.
Table 2-2
Materials Needed
One wall mount bracket
Four M6 x12mm hex head bolts
Two stainless steel band clamps (adjustable 2"–5", 51–127
mm)
Two stainless steel band clamps (adjustable 5"–8", 127–203
mm)
10 mm box-end wrench
Outdoor rated shielded Ethernet cable
Ground lug (provided with the access point)
Ground block and rod
Crimping tool for ground lug, Panduit CT-720 with CD-720-1
die (http://www.panduit.com)
#6 AWG ground wire
To mount the access point onto a vertical pole, follow these steps:
Step 1 Select a mounting location on the pole to mount the access point. You can attach the access point to a
pole having a diameter of 2 to 8 inches (5.1 to 20.1 cm).
Note
Step 2 Hold the bracket up against the pole, and slide the two band straps through the top and bottom sets of
mounting slots on the mounting bracket (see
Step 3 Wrap the band straps around the pole, lock them, and then lightly tighten the clamps using a wrench.
Only tighten them enough to keep the bracket from sliding down the pole
Step 4 Screw an M6 bolt into each of the four bolt holes on the back side of the access point. Do not screw the
bolt in all the way. Leave a gap of about 0.13-inch (3.3 mm).
Step 5 Position the four bolts on the access point into the bracket keyhole slots. Check to be sure that the access
point is properly seated in the slots (see
Note
Step 6 Using a 10 mm wrench, tighten the four bolts that connect the access point to the bracket to a torque of
40 lbf-in.
Materials Needed to Mount the AP on a Vertical Pole
If you will be using a streetlight power tap adapter, position the access point within 3 ft (1 m) of
the outdoor light control. An AC/DC adapter needs to be used for street light pole deployments.
The access point should be mounted with the status LED on the base facing downwards.
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
In Kit?
Yes
Yes
Yes
Yes
No
No
Yes
No
No
No
Figure 2-4).
Figure 2-4).
Mounting the Access Point
2-9