Cisco Aironet 1570 Series Installation Manual page 60

Strand Mount Kit 3
Figure 3-10
1
3
5
Step 2 Secure each cable bracket with two M8 x16 bolts (with lock washers) on the back surface of the access
point.
When installing external antennas, which are mounted on the AP using an additional antenna bracket,
Tip
the AP may tilt to one side due to the uneven weight distribution. To counteract this tilt, elongated M8x16
bolt holes are provided on the cable bracket. This allows you to adjust the cable brackets' position
against the AP's back surface, to cancel the tilt.
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
3-16
Assembling Cable Clamps on Cable Bracket
1
5
5/16"-18 bolt
5/16"-18 nut with washer
5/16"-18 bolt and nut for the
height-adjustable cable bracket
(Figure 3-12). Hand-tighten the bolts to 13 to 15 lb.ft (17.6 to 20.3 Nm).
Chapter 3
2
4
2 Cable Clamps
4 M8 x16mm bolt
Mounting the Access Point
3
OL-32138-01