Cisco Aironet 1570 Series Installation Manual page 119

Chapter 4 Installing Other Components
Figure 4-13
1 Thread end
The cable gland can accept cables of diameter from 0.20 to 0.35 in. (0.51 to 0.89 cm).
Note
Insert a bare end of the DC power cable into the rounded end of the cable gland (see
Step 5
pull approximately 6 inches of cable through the adapter.
When installing the DC power cable, ensure that cable gland and the rubber gasket are present and
Warning
installed properly, to avoid water leakage into the enclosure.
Strip the DC cable jacket back by about 1 inch to expose the wires and then strip the insulation by about
Step 6
0.5 inch (or 12 mm) from each wire.
Push in the orange colored spring-loaded securing tabs and insert the wire (see
Step 7
into the two-position terminal block connector (Cisco Part Number 29-100226-01,
then release the tabs. Tug on the wire to ensure that it is properly secured.
Figure 4-14
OL-32138-01
Cable Gland
Push in the securing tab, and wire, as the arrow shows
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
2 Round end
Powering the Access Point
Figure 4-13), and
Figure 4-14) all the way
Figure 4-15), and
4-23