Back Of The Ap - Cisco Aironet 1570 Series Installation Manual

Parts of each Access Point Model

Back of the AP

The Back of the access point is identifiable by the radiation fins, and also the screw holes that are used
when mounting the AP on the supported mounting kits. The back of the AP faces upwards when the AP
is mounted in a horizontal orientation. The back of the AP on AP1572IC and AP1572EC (see
is different from that of AP1572EAC (see
Figure 1-4 Back of the AP on AP1572IC and AP1572EC
1
1 Four screw holes for M8 x16mm bolts used to fasten
the AP onto mounting kits.
3 Spot for mounting the GPS antenna.
5 Screw covering Cable RF Attenuator, labeled "7".
Cable RF Attenuator provided only in AP1570IC and
AP1570EC models. Not provided in AP1570EAC
model.
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
1-6
Figure 1-5).
2
3
4
5
2 Port for GPS antenna connector.
4 Screw covering Fuse/Shunt port, labeled "8".
Fuse/Shunt port is provided only in AP1570IC and
AP1570EC models. Not provided in AP1570EAC
model.
Chapter 1 Product Overview
Figure 1-4)
OL-32138-01