Cisco Aironet 1570 Series Installation Manual page 57

Chapter 3 Mounting the Access Point
Place the cable bracket, attached to the AP, on the cable strand, with each pair of cable clamps clamping
Step 3
on to the cable strand. Then, tighten the cable clamps by tightening the two 5/16"-18 nuts to 13 to 15 lb.ft
(17.6 to 20.3 Nm). See
Figure 3-7 Attaching the Cable Mount Brackets to the Cable Strand
4
1
3
Note
OL-32138-01
Figure 3-7.
1
Cable Strand/Support Cable running
though center cable grooves
5/16"-18 bolt, flange washer, and
cable clamps, which clamp the
support cable to the cable bracket
During installation, the cable strand/support cable might have to be pulled away from the fiber
or cable bundle. Be sure to resecure the cable after installation.
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
2
2 Cable bracket assembly
4 M8 x16mm button-head bolts, which fasten the
cable bracket assembly to the AP.
Strand Mount Kit 2
3
3-13