Cisco Aironet 1570 Series Installation Manual page 62

Strand Mount Kit 3
Place the cable bracket, attached to the AP, on the cable strand, with each pair of cable clamps clamping
Step 3
on to the cable strand. Then, tighten the cable clamps by tightening the two 5/16"-18 nuts to 13 to 15 lb.ft
(17.6 to 20.3 Nm). See
Figure 3-12 Attaching the Cable Mount Brackets to the Cable Strand
1
6
1
2
3
Note
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
3-18
Figure 3-12.
2
5
5/16"-18 bolt, flange washer, and
cable clamps, which clamp the
support cable to the height-adjustable
cable bracket
Cable bracket assembly
Cable Strand/Support Cable running
though center cable grooves
During installation, the cable strand/support cable might have to be pulled away from the fiber
3
4 5/16"-18 bolt and nut for the height-adjustable
cable bracket
5 M8 x16mm button-head bolts, which fasten the
cable bracket assembly to the AP
6 5/16"-18 bolt and nut for the height-adjustable
cable bracket
Chapter 3 Mounting the Access Point
4
OL-32138-01