Optional Ap Hardware; Tools And Hardware Common For All Mounting Options - Cisco Aironet 1570 Series Installation Manual

Chapter 3 Mounting the Access Point
•

Optional AP Hardware

Depending on your requirements, you can order the following optional equipment from Cisco as part of
your shipment:
•
•
•
•

Tools and Hardware Common For All Mounting Options

The tools and hardware required for each mounting option, is listed in the corresponding sections. The
following tools and materials are required during various stages of installing the AP, for all mounting
options:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
OL-32138-01
Cisco product documentation pointer card
Strand mounts kits
Pole mount kits
External antennas
GPS antenna
10 mm open end or box wrench, for M6 bolts
13 mm box-end wrench or socket set, for M8 bolts
Adjustable wrench with opening up to 33 mm and 28 mm socket.
0.5 inch or 13 mm wrench (for port plugs)
Ground lug crimping tool (Panduit CT-720 with CD-720-1 die)
6-AWG copper ground wire
Small flat-screwdriver for DC power connector
Optional shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.20 to 0.35 in
(0.51 to 0.89 cm) diameter
Optional Ethernet RJ-45 connector and installation tool
Optional shielded outdoor-rated DC power cable with 0.20 to 0.35 inch (.0.51 to 0.89 cm) diameter,
rated at 10 amp, 10-16 V DC cable.
Optional ground rod, as required by local regulations
Optional ladder, power lift, rope, or other tools as required
5/16" socket wrench (alternative to M8 bolts) for PMK1 mount clamp
Installation tool for the steel band straps (AIR-BAND-INST-TL=) for fastening the strap brackets
when using PMK2 and PMK3.
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
Optional AP Hardware
3-3