Ap Model Numbers And Regulatory Domains - Cisco Catalyst Wireless 9164I Series Installation Manual

About the Access Point
• Local mode: This is the default mode for the AP. In this mode, the AP serves clients. The AP creates
two CAPWAP tunnels to the controller, one for management and the other for data traffic. This is known
as central switching because the data traffic is switched (bridged) from the AP to the controller where it
is then routed.
• FlexConnect mode: In FlexConnect mode, the data traffic is switched locally and is not sent to the
controller. In this mode, the AP behaves like an autonomous AP, but is managed by the controller. Here,
the AP can continue to function even if connection to the controller is lost.
• Monitor mode: In this mode, specified Cisco APs can exclude themselves from handling data traffic
between clients and the infrastructure. These APs act as dedicated sensors for location-based services
(LBS), rogue AP detection, and intrusion detection system (IDS).When APs are in monitor mode, they
actively monitor the airwaves and typically, do not serve clients.
• Sniffer mode: In this mode, the AP starts sniffing the air on a given channel. It captures and forwards
all the packets from the clients on that channel to a remote machine that runs AiroPeek NX or Wireshark
(packet analyzers for IEEE 802.11 wireless LANs). This includes information on timestamp, signal
strength, packet size, and so on.
Note
• Site Survey mode: The AP GUI is enabled and is used for configuring the RF parameters for site survey
investigation. For information, see the
Series Wireless Controller Software Configuration Guide.

AP Model Numbers and Regulatory Domains

AP Type
Access Point for indoor environments, with
internal antennas
Verify whether the AP model you have is approved for use in your country. To verify approval and to identify
the regulatory domain that corresponds to a particular country, see
In the sniffer mode, the server to which the data is sent should be on the same
VLAN as the wireless controller management VLAN. Otherwise, an error message
is displayed.
Cisco Catalyst Wireless 9164I Series Wi-Fi 6E Access Point Hardware Installation Guide
AP Model Numbers and Regulatory Domains
Access Points Survey Mode section in the Cisco Catalyst 9800
Product ID
CW9164I-A
CW9164I-B
CW9164I-E
CW9164I-F
CW9164I-Q
CW9164I-R
CW9164I-Z
CW9164I-ROW
CW9164I-MR
https://www.cisco.com/c/dam/assets/prod/
Details
Wi-Fi 6E AP, tri-band, 802.11ax with inter
3