Initial Preparations; Guidelines - Bosch EX40 Installation Instructions Manual

INITIAL PREPARATIONS

 Determine the operating voltage at the installation
site. The camera's Voltage Regulator Board
accepts either 12V dc or 24V ac input.
See Section 2, Input Power Connections.
 Determine the optimum location for the camera.
Section 3, Mounting-Camera Base.
 All cameras have been tested prior to shipment.
After the wiring has been reconnected, it is
advisable to check the camera's operation before
installation.
 ESD protection – Cameras and circuit boards are
sensitive electronic components. It is
recommended to wear a ground strap to ground
any static charge. (Alternative: touch a grounded
metal plate for at least a minute before proceeding
with any disassembly)

GUIDELINES

The installation of the EX40 camera is explained in
Sections 1 to 5 listed below. It is important that
these steps are followed in sequence:
1. Dome Removal
2. Input Power Connections
3. Mounting - Camera Base
4. Directional Adjustment
5.
Camera Re-Assembly
3