Table of Contents
Advertisement
INITIAL PREPARATIONS
•
Determine the operating voltage at the
installation site. The camera's Voltage Regulator
Board accepts both 12-24VDC and VAC input
without change to internal connections.
See Section 2, Input Power/Video Output
Connections.
•
Determine the optimum location for the camera.
See Section 3, Mounting Specification.
•
All cameras have been tested prior to shipment.
After the wiring has been reconnected, it is
advisable to check the camera's operation
before installation.
Note: To ensure the camera is working, you must
use a retro reflective license plate.
GUIDELINES
The installation of the REG-L1 camera is explained in
Sections 1 to 3.
It is important that these steps are followed and practice
proper installation procedures with proper safety
equipment.
- 3 -
Advertisement
Table of Contents
