10
en | Installation
3
Installation
3.1
Initial Preparations
-
-
-
-
Installation Step
3.2
Faceplate Removal
You must remove the faceplate prior to installation in order to
reach the mounting holes. You may need to change the
directional angle of the lens. Refer to Figure 3.1.
1.
2.
3.
F.01U.172.707 | 3.0 | 2011.02
Determine the operating voltage at the installation site.
Determine the optimum location for the camera. Refer to
Section 3.4 Mounting the Camera Housing.
All units have been tested prior to shipment. After the
wiring has been reconnected, check the unit's operation
before installation.
Follow these installation steps in sequence:
Place the camera housing on a flat surface.
Use the supplied hex key to remove the six screws holding
the faceplate into the housing.
Remove the square foam cushion attached to the camera
lens.
Instruction Manual
Corner-mount No-grip Camera
PAGE
Page 10
Page 12
Page 13
Page 15
Page 16
Page 18
Bosch Security Systems, Inc.