Rogue Ap Detection Commands - D-Link DAP-3220 Reference Manual

Command
find rogue Find rogue AP
rogue add Add a Rogue Access Point Result Entry
Del a Rogue Access Point Result Entry from the scanned result(in
rogue del
SDRAM).
rogue deleep Del a Rogue Access Point Result Entry ,which had been stored in Flash. rogue deleep <index>
Display Rogue Access Point Detection Result in the scanned result(in
rogue list
SDRAM).
Display Rogue Access Point Detection Result, which had been stored in
rogue listeep
Flash.
Get Command
get roguebsstype Display Rogue AP BSS type
get roguesecurity Display Rogue AP Security Type
get roguebandselect Display rogue AP Band Select
get DeAssoEnable Display Rogue AP Protection State
Set Command
set roguestatus Enable or Disable Rogue AP function
set roguebsstypestatus Enable or Disable Rogue AP BSS Type function
set roguebsstype Set Rogue AP BSS Type
set roguesecuritystatus Enable/Disable Rogue AP Security
set roguesecurity Set Rogue AP Security Type
set roguebandselectstatus Set Rogue AP Band Select status
set roguebandselect Set ROGUE AP Band Select
set DeAssoEnable Set Rogue AP Protection State
802.11 b/g Access Point Command Line Interface Manual
Function
Function
Function
21
10
R AP D
OGUE ETECTION
Syntax
find rogue
rogue add <index>
rogue del <index>
rogue list
rogue listeep
Syntax
get roguebsstype
get roguesecurity
get roguebandselect
get DeAssoEnable
Syntax
set roguestatus [disable:enable]
set roguebsstypestatus [disable:enable]
set roguebsstype [apbss:adhoc:both]
set roguesecuritystatus [disable:enable]
set roguesecurity
Note: After enter this command, the CLI will list the security type for
selection
set roguebandselectstatus [disable:enable]
set roguebandselect
Note: After enter this command, the CLI will list the security type for
selection
set DeAssoEnable [disable:enable]
C
OMMANDS