D-Link DAP-3220 Reference Manual page 13
802.11b/g access point
Hide thumbs
Also See for DAP-3220:
- Quick installation manual (76 pages) ,
- User manual (69 pages) ,
- Install manual (10 pages)
Table of Contents
Advertisement
set beaconinterval
Modify Beacon Interval 20-1000
set dtim
Set Delivery Traffic Indication Message Beacon Rate. Default is 1
set fragmentthreshold
Set Fragment Threshold
set rtsthreshold
Set RTS/CTS Threshold in bytes
set power
Set Transmit Power in predefined increments
set SuperG
Enable or Disable Super G Features
set wlanstate
Select the operational state of wlan: enabled or disabled
set shortpreamble
Set Short Preamble
set wirelessmode
Used to select the wireless mode of operation for the AP: 11b, 11g, 108g set wirelessmode [11b:11g:108g]
set 11gonly
Only 802.11g clients will be Allowed to connect to this BSS
set antenna
Set Antenna selection of 1, 2, or best
set aging
Set Aging Interval
set channel
Select Radio Channel of Operation
set diap
Enable or Disable DIAP
set eth2wlan
Enable or Disable the Eth2Wlan Broadcast packet filter feature
set sta2sta
Set wireless STAs to wireless STAs connect state (WLAN Partition)
set eth2sta
Set ethernet to wireless STAs connect state
set ratecontrol
Enable/Disable supported data rate
set supportrate
Modify supported data rate(bit mask)
Security
Del Command:
del key
Delete Encryption key
Get Command:
get encryption
Display (WEP) configuration state (enabled or disabled)
get authentication
Display Authentication Type
Display Encryption cipher type
Explanation:
Response WEP for choosing WEP
get cipher
Response Auto for choosing WPA-Auto
Response AES for choosing WPA-AES
Response TKIP for choosing WPA-TKI
802.11 b/g Access Point Command Line Interface Manual
Function
Function
11
set beaconinterval [20-1000]
set dtim <1-255>
set fragmentationthreshold <xxxx>
set rtsthreshold <xxxx>
set power [full:half:quarter:eighth:min]
set SuperG [disable: enable]
set wlanstate [disable: enable]
set shortpreamble [disable: enable]
set 11gonly [disable:enable]
set antenna [1:2:best]
set aging <seconds>
set channel [1:2:3:4:5:6:7:8:9:10:11]
set diap [disable:enable]
set eth2wlan [0:1]
Explanation: 0=disable:1=enable
set sta2sta [disable: enable]
set eth2sta [disable: enable]
set ratecontrol [disable:enable]
set supportrate
Syntax
del key [1-4]
Syntax
get encryption
get authentication
get cipher
Advertisement
Table of Contents
