Nokia 6111 RM-82 Service Manual page 81

RM-82
Phoenix service SW
6. Click Finish to complete the installation.
7. Connect the USB cable/JBV-1 to your computer. Connect power to JBV-1 (11-16V DC) from an external
power supply, then connect the USB Cable between the JBV-1 USB connector and the PC.
8. Install or update the JBV-1 USB drivers which are delivered with the JBV-1 SW installation package.
The drivers can be found in
• If there is no previously installed JBV-1 Firmware update package installed on your computer,
Windows will detect connected USB cable and detect drivers for new HW. You will be prompted about
this, please follow the instructions and allow Windows to search and install the best drivers available.
• If there is a previously installed JBV-1 Firmware update package (v.17 or older) on your computer,
please update the JBV-1 USB driver. Please see the
Firmware Update\JBV-1USB driver folder for instructions on how to update the JBV-1 USB Driver.
After you have installed or updated the JBV-1 USB driver, the actual JBV-1 SW update can begin.
C:\Program Files\Nokia\JBV-1 Firmware Update\JBV-1 Firmware Update and start JBV-1
9. Go to folder
Update SW by double clicking
JBV-1 Firmware update starts and shows current status of the connected JBV-1. If firmware version read
from your JBV-1 is not the latest one available (v.17 or older), it needs to be updated to version 18 by
clicking Update Firmware.
Issue 1
Figure 68 Finish JBV-1 update installation
C:\Program Files\Nokia\ JBV-1 Firmware Update\JBV-1USB driver
fwup.exe .
COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All rights reserved.
readme.txt file in C:\Program Files\Nokia\JBV-1
Nokia Customer Care
Page 3 –41