Technical Specifications; General Specifications; Battery Endurance; Environmental Conditions - Nokia 6111 RM-82 Service Manual

Nokia Customer Care
The Bluetooth has a separate built in antenna and is powered by VBAT and the regulated voltage VIO. For
audio applications the Bluetooth has a PCM data bus. In addition a UART (universal asynchronous receiver/
transmitter) is used for data communication and controls.
Bluetooth connects to TikuEDGE on the GENIO and GPIO busses.
The Bluetooth module is provided with power from an external LDO (Low drop out) regulator.
FM radio and Bluetooth are physically placed in the same module, but they function separately and
independently from each other. Information about the
module section.

Technical specifications

General specifications

Unit
Transceiver with BL-4B
700 mAh Li-Ion battery
pack

Battery endurance

Battery
BL-4B 700 mAh Li-ion
Note: Variation in operation times will occur depending on SIM card, network settings and usage.
Talk time is increased by up to 30% if half rate is active, and reduced by 5% if enhanced full rate is
active.

Environmental conditions

Temperature
Temperature range
Operational (all specs met)
Functional (reduced
performance)
Storage
The HW module complies with the SPR4 Operating Conditions.
Humidity
Relative humidity range is 5...95%.
The hardware module is not protected against water. Condensed or splashed water might cause malfunction.
Any submerge of the phone will cause permanent damage. Long-term high humidity, with condensation,
will cause permanent damage because of corrosion.
The hardware module complies with the SPR4 Operating Conditions.
Page 9 –18
Dimension (mm)
RM-82: 84x47x23
Talk time
3.20 hours
o
Min C
-10
-30
-30
COMPANY CONFIDENTIAL
Copyright © 2005 Nokia. All rights reserved.
FM radio (page 9–12)
Weight (g)
RM-82: 88g
Standby time
Up to 8 days
Max
+55
+70
+85
System module
can be found in the System
Volume (cc)
RM-82: 76cc
o
C
RM-82
Issue 1