Door Lock - Asko OP8621S Operating Instructions Manual

Door lock (only with
some models)
• With GentleClose door system, rotate the stoppers back by
90°(Figure 2).
fi gure 2
• Slowly close the door until the clips are pressed against the
supports / seats. At approximately 15° (relative to the closed
door position), pull the door slightly upward and pull them out
of the both hinge supports on the appliances (Figure 3).
• Replace the door in the reverse order. Insert the door under
an angle of 15° into the hinge supports at the front side of the
appliance and push them downwards and to the front until they
slide into their supports / seats.
fi gure 3
• Then, completely open the door and rotate the attachment
clips back to their initial position. Slowly close the door and
check, if they close properly. If the door does not open or close
correctly, make sure whether the hinge notches are correctly
placed in their seat hinges.
Attention
Always make sure the hinge attachment clips are fi rmly seated in
their supports when installing the door. If this is not the case, the
main hinge that is operated by a strong spring may be released
any time while installing or removing the door. Risk of physical
injury.
• Oven door is fi tted with a door lock that prevents it from being
open until the lock is released. Door lock is opened by a
slightly pressing your thumb to the right and simultaneously
pulling the door outwards.
• When the oven door is closed, the door lock automatically
returns to its initial position.
Note: If the door lock is supplied with the appliance, attach
it under the appliance control panel in compliance with the
instructions for installation, which are supplied with the lock.
41