Sensor Safety Lock; Beep; Setting The Audible Signal Volume; Changing The Pace Of Changes To The Settings - Asko OP8621S Operating Instructions Manual

20
When the symbol I2 is lit, the oven is still heating up; when the
set temperature is reached, the symbol goes off and it does not
reappear during the cooking process.

Sensor safety lock

Use this function to prevent any unwanted operation of the oven
(e.g. as a child lock).
• Activate the function by pressing the (B) sensor key and
holding it for three seconds.
• All sensors will be locked, except for the appliance on/off
sensor (A) and the safety lock sensor (B).
• If any other sensor is pressed, a beep will sound, and the key
symbol (B) will fl ash quickly.
• The safety lock is deactivated by pressing and holding the (B)
key again.

Beep

Every time a sensor key is pressed, this is acknowledged by
a short beep.
The sound signal for the end of cooking process will be
active for one minute. It can be cancelled earlier by pressing
any sensor key.

Setting the audible signal volume

The volume (loudness) of the beep can be set as follows:
• Touch the (E) sensor key and hold it for approximately three
seconds; volume settings will appear on the display.
• Use the (H) keys "+, -" to set the desired volume level.
- "oooo" for maximum volume
- "o" for minimum volume.
• The last selected setting will be stored automatically.

Changing the pace of changes to the settings

When any value, or setting, is being changed, it is fi rst changed
slowly; when any of the (H) keys "+, -" is held for three seconds,
the pace at which the value is changing will accelerate.
In case of a power failure that lasts for less than one
minute, all settings will remain unaffected and the oven
will continue its operation (if turned on).