Table of Contents
Advertisement
Installing the Chassis
Chapter 2
N
:
Alcatel ships a country appropriate cable with the Alcatel OmniAccess
OTE
4302 WLAN Switch. However, any power cord rated for the Alcatel
OmniAccess 4302 WLAN Switch power consumption and which
conforms to grounded electrical standards in the country where the
product will be operated can be used (see
Use of a power line conditioner or Uninterruptible Power Supply (UPS) can
decrease or mitigate problems caused by power service fluctuations. Make sure
that the output of any power shaping device is compatible with the Alcatel
OmniAccess 4302 WLAN Switch power supply.
N
:
Additional power adapters can be ordered separately.
OTE
Verifying the Installation
After the Alcatel OmniAccess 4302 WLAN Switch is installed and connected to
power, verify the following:
1.
Check that the system Power LED lights solid green immediately upon power
up and remains solid green during and after bootup.
N
:
The system Status LED remains off until you perform the initial
OTE
setup.
For more information on LED behavior, see
page 4.
2.
Connect appropriate network cables (see
page 4
and
3.
Perform the initial setup as described in the Alcatel Quick Start Guide (which
is included in the Accessory Kit).
10
OmniAccess 4302 WLAN Switch
Installation Guide
"Gigabit Ethernet LAN Port" on page 5
"Specifications" on page
"System Indicator LEDs" on
"Fast Ethernet WAN Port" on
for cable information).
13).
031986-00
February 2006
Advertisement
Table of Contents
