Using Vocal Harmony - Yamaha Tyros5-76 Owner's Manual

5
Adjust the volume balance between the microphone sound and
the instrument sound on the BALANCE display (page 61).
Disconnecting the microphone
1
Set the [MIC GAIN] knob to the minimum position.
2
Disconnect the microphone from the [MIC INPUT] jack.

Using Vocal Harmony

This section covers the Vocal Harmony Effects that can be applied to your voice via the microphone sound.
1
Connect the microphone to the instrument (page 88).
2
Press the [VH TYPE SELECT] button to call up the Vocal Har-
mony Type Selection display.
5
2
3
Use the TAB [][] buttons to select the VOCAL HARMONY
tab.
4
Use the [A]–[J] buttons to select the desired Vocal Harmony
type.
The Vocal Harmony features three different Modes which can be selected auto-
matically by selecting a Vocal Harmony type.
Icon
(Microphone)
(Microphone with FX)
(Microphone and keyboard)
5
If necessary, press the [VOCAL HARMONY] button to turn the
function on.
NEXT PAGE
Mode Descriptions
Chordal The harmony notes are determined by the chords you play in the chord sec-
tion (with [ACMP] turned on), the left hand section (with [ACMP] turned off
and [LEFT] turned on) or the chord data of a Song.
The harmony notes are determined in the same way as in Microphone above.
However, effects such as Vocal Doubler and Short Delay are applied. Har-
mony may or may not be applied depending on the selected type. (If har-
mony is not applied, the [VOCAL HARMONY] button is not lit.)
Vocoder The microphone sound is output via the notes you play on the keyboard or
via the Song playback notes.
Vocoder-Mono Same as the Vocoder basically. In this mode, only single-note melodies or
lines can be played back (with last-note priority).
3
4
Tyros5 Owner's Manual
8
89