Emerson Rosemount 3051 Quick Start Manual page 15

August 2016
Before you begin
See Figure 9
configuration. Before beginning configuration, you may need to verify the device
tag or deactivate hardware and software write protection on the transmitter. To
do this follow
configuration".
1. To verify the device tag:
a. Navigation: from the Overview screen, select Device Information to verify
the device tag.
2. To check the switches (see
a. The write lock switch must be in the unlocked position if the switch has
been enabled in software.
b. To disable the software write lock (devices ship from the factory with the
software write lock disabled):
Navigation: from the Overview screen, select Device Information and

then select the Security and Simulation tab.
Perform Write Lock Setup to disable software write lock.

Note
Place the control loop in "Manual" mode before beginning analog input block
configuration.
AI block configuration
To use guided setup:
Navigate to Configure>Guided Setup.

Select AI Block Unit Setup.

Note
Guided setup will automatically go through each step in the proper order.
Note
For convenience, AI block 1 is pre-linked to the transmitter primary variable and should be
used for this purpose. AI block 2 is pre-linked to the transmitter sensor temperature. The
channel must be selected for AI blocks 3 and 4.
Channel 1 is the primary variable.

Channel 2 is the sensor temperature.

If the F
OUNDATION
additional channels are available.
Channel 12 is the SPM mean.

Channel 13 is the SPM standard deviation.

To configure SPM, refer to the Rosemount 3051 F
Manual.
to graphically view the step by step process for basic device
Step 1 and Step 2
Figure
Fieldbus Diagnostics Suite Option Code D01 is enabled, these
below. Otherwise continue at
7):
OUNDATION
Quick Start Guide
"AI block
Fieldbus Reference
15