Level Service Manual
6809513A81-A
5.
Insert the disassembly tool between the front and rear flip housing to unlatch the flip catches
in the sequence shown below. Separate the flip rear & front housing after all catches are
being unlatched.
Figure 12. Separating the Flip Front Housing from the Flip Rear Housing
6.
To replace, align the flip rear housing to the flip assembly and carefully press downwards
to engage the 7 latches.
7.
Turn the flip assembly over & insert the 4 flip screws. Tighten with a T-5 torque driver to
a final torque setting of 1.4 +/- 0.1 lbs.
April 01, 2008
Disassembly
27