Technical Data - Bosch PCL 10 Original Instructions Manual

Technical Data

Cross-line Laser
Article number
Working range to approx.
Levelling accuracy
Self-levelling range,
typically
Levelling duration, typically
Operating temperature
Storage temperature
Relative air humidity, max.
Laser class
Laser type
C
6
Tripod mount
Batteries
Operating life time, approx.
Weight according to
EPTA-Procedure 01/2003
Dimensions
Please observe the article number on the type plate of
your measuring tool. The trade names of the individual
measuring tools may vary.
Assembly
Inserting/Replacing the Battery
Use only alkali-manganese batteries.
To open the battery lid 5, press on the latch 4 and
fold the battery lid up. Insert the batteries. When
inserting, pay attention to the correct polarity
according to the representation on the inside of
the battery compartment.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Remove the batteries from the measuring
tool when not using it for extended periods.
When storing for extended periods, the bat-
teries can corrode and discharge themselves.
Bosch Power Tools
PCL 10
3 603 K08 1..
10 m
± 0.5 mm/m
± 4°
4 s
+5 °C ... +40 °C
– 20 °C ... +70 °C
90 %
2
635 nm, <1 mW
>10
1/4"
2 x 1.5 V LR6 (AA)
15 h
0.4 kg
108 x 66 x 92 mm
Operation
Initial Operation
Protect the measuring tool against moisture
and direct sun irradiation.
Do not subject the measuring tool to extreme
temperatures or variations in temperature.
As an example, do not leave it in vehicles for
longer periods. In case of large variations in
temperature, allow the measuring tool to ad-
just to the ambient temperature before putting
it into operation.
Avoid heavy impact to or falling down of the
measuring tool. Damage to the measuring
tool can impair its accuracy. After heavy im-
pact or shock, compare the laser line with a
known horizontal or vertical reference line.
Switch the measuring tool off during trans-
port. When switching off, the levelling unit,
which can be damaged in case of intense
movement, is locked.
Switching On and Off
To switch on the measuring tool, push the
On/Off switch 3 to the "On" position. Imme-
diately after switching on, the measuring tool
sends two laser beams out of the exit opening 1.
Do not point the laser beam at persons or
animals and do not look into the laser beam
yourself, not even from a large distance.
To switch off the measuring tool, push the
On/Off switch 3 to the "Off" position. When
switching off, the levelling unit is locked.
Do not leave the switched on measuring tool
unattended and switch the measuring tool
off after use. Other persons could be blinded
by the laser beam.
English | 11
1 609 929 R04 | (13.6.08)