Defining The Control Characters Packet - Paxar Monarch 9412 Reference Manual

D e f i n i n g t h e C o n t r o l C h a r a c t e r s P a c k e t
Use the control characters packet (E) to change the MPCLII
control characters, enable and disable the immediate commands,
and change the default terminator character for job requests and
ENQ's.
Changes take effect with the first character following the end of
header character } of the configuration packet. Each control
character must be unique and cannot appear anywhere else in
your packet, except within quotation marks. You can customize
the trailer characters to work with your host.
Wait two seconds for the new characters to
take effect before sending packets using the
Use the following syntax for the control characters packet. Notice
all but the first parameter are within quotation marks.
Syntax
E1. E Control Characters Packet
E2. "ANSI_cd" ~123
~044
~034
~124
~125
~126
def. ch.
NOTE: "ANSI_cd" includes seven separate parameters. The
new characters.
{I,E,"ANSI_cd","string1","string2"
Start of header
Parameter
separator
Quoted strings
Field separator
End of header
Data escape
character (optional)
Immediate command character (optional).
Up to any 3 digits in the 0 to 255 decimal
range. The tilde (~) must be used with decimal
characters. The character must be defined before
this command can be used. The caret (~094) is
normally used.
first five parameters are required. The other
parameters are optional.
{ (left bracket)
, (comma)
" (quotes)
(pipe sign)
} (right bracket)
~~ (double tilde)
Configuring the Printer 3-13
}