Table of Contents
Advertisement
Command
Cancels all the batches in the queue.
^CA
Cancels only the current batch being printed.
^CB
Disables the MPCL data escape character (the tilde) and inhibits MPCL
^DD or
from acting on ANY data escape sequence from the host. Sets the MPCL
^DCd
data escape character to the ASCII value given by the d parameter. The
value can be any ASCII character.
Aborts an error condition. May need to be sent multiple times. Use ^RB to
^EA
reprint batch.
CAUTION: Command causes the current batch to stop and the
Resets the error. This command is the same as pressing FEED to
^ER
acknowledge an error. Normal operation will resume.
Feeds a label when printer is idle. Simulates the operation of pressing
^FD
FEED and dispenses the next label if printer is in the on-demand mode.
NOTE:
^ID or ^ICd Disables the Immediate Command feature by turning off the Immediate
Command escape character. Sets the Immediate Command escape
character to the ASCII value given by the d parameter. The value can be
any ASCII character.
Returns the customer ID or RPQ version to the host. (00 to 99)
^MC
Returns the customer ID or RPQ revision level to the host. (00 to 99)
^MI
Returns the model number to the host. 12=9412, 13=9413, 14=9414
^MM
Returns the prototype number to the host. (00 to 99)
^MP
Returns the revision number to the host. (00 to 99)
^MR
Returns the version number to the host. (00 to 99)
^MV
Resets the printer. This command takes five seconds to complete and then
^PR
the printer is ready to receive data. It has the same effect as turning off
and then turning on the printer.
NOTE: Command should be used only when the printer is not printing.
Repeats the last printed batch, printing the same number of labels as
^RB
specified in the original batch.
NOTE: Printer ignores this command if printing.
This command does not work if batch separators are being used.
Resynchronizes supply when supply roll is changed.
^RS
NOTE: Printer ignores this command if printing.
Disables the status polling feature by turning off the status polling control
^SD or
character. Sets the status polling control character to the ASCII value
^SCd
given by the d parameter. The value of d can be any ASCII character.
Prints a test label set. NOTE: Printer ignores this command if printing.
^TP
condition that caused the error to remain uncorrected.
Printer ignores this command if printing.
Parameter
Configuring the Printer 3-23
Advertisement
Table of Contents
