Defining The Communication Settings Packet - Paxar Monarch 9412 Reference Manual

Be careful when using this feature. If you forget what the control
characters were changed to, print a test label. The test label lists
the current control characters. See "Printing a Test Label," in
Chapter 8 for more information.
D e f i n i n g t h e C o m m u n i c a t i o n S e t t i n g s P a c k e t
Use the communication settings packet (F) to set the baud rate,
word length, stop bits, parity, and flow control for serial
communications. To set parallel communications, see "Using
Parallel Communications." Changing the communication settings
takes approximately two seconds. Communications sent during
this interval will be lost. Make sure the host communication
values match the values on the printer.
Syntax
F1. F Communication Settings Packet
F2. baud Baud Rate. Options:
F3. word_length Word Length. Options:
F4. stop_bits Stop Bits. Options:
F5. parity Parity. Options:
F6. flow_control Flow Control. Options:
NOTE: If you use the DOS COPY command to download
{I,F,baud,word_length,stop_bits,parity,
flow_control
0 1200
1 2400
2 4800
0 7-bit word length
1 8-bit word length (default for all printers)
0 1-stop bit (default for all printers)
1 2-stop bits
0 None (default for all printers)
1 ODD parity
2 EVEN parity
0 None
1 DTR (default
for all printers)
your formats, set "Flow Control" to DTR (not
XON/XOFF).
}
3 9600 (default for all printers)
4 19200
5 38400
2 (CTS)
3 XON/XOFF
Configuring the Printer 3-15