Carrier Assembly - Polaris Outlaw 500 Service Manual

BODY / STEERING / SUSPENSION
5. Disassemble, clean and inspect the upper A-arm bushings
and shaft. Replace components as required.
6. Disassemble, clean and inspect the lower A-arm thrust
washers, needle bearing, seals and shaft. Replace
components as required.
Thrust
Washer
Seal
Needle Bearing
7. Inspect needle bearing performance by rotating the shaft
inside the bearing. If replacement is required, press the
bearings out from opposite sides using a drift punch or other
suitable tool.
Bearing Removal
5.26

Carrier Assembly

1. Assemble and install the upper A-arm bushings and shaft.
2. Install needle bearings by pressing the bearings into the
housing using a suitable tool.
Shaft
3. Apply grease and install the shaft. Install the lower A-arm
seals.
Bearing Installation
Thrust
Washer
Seal
Shaft
RepairPro Service Manual